USRobotics NETServer/16 Uživatelský manuál stáhnout pdf (Strana 190)

10-40 Command Reference

IMPORTANT: Without a user table entry, the NETServer can’t

tell what type of user is dialing in. If security is off, network

users who are not part of the User Table are assumed to be login

users and passed on to a host. Security should be on if network

dial in users will be using the port.

User Login Port Parameters

The following parameters apply only to user login ports.

Autolog Name

Assigning an Autolog Name to a port effectively does two

things:

• The port behaves as if the Security setting is turned off

except that users are connected to the Port Default Host

immediately. They will not see a login prompt from the

NETServer.

• If the Port Default Login Service is set to Rlogin or PortMux,

the NETServer will automatically enter the autolog name at

the Default Host’s login prompt. The first thing the user will

see is the corresponding password prompt.

Note: Since Telnet and Netdata cannot automatically enter

user names, users connecting to ports using one of these

services will receive a login prompt from the host before

they see the corresponding password prompt.

The Autolog name can be up to 8 characters long. Use the

following command:

set s<port #> autolog <user name>

Dialback Delay

This specifies how many seconds a port will wait to return a

dialback user’s call. This is useful for allowing the remote

system more time to get ready for an incoming call. The default

is 0 (no delay). Use the following command:

set s<port #> dialback_delay <seconds>

1 2 ... 185 186 187 188 189 190 191 192 193 194 195 ... 283 284

Žádné komentáře

USRobotics NETServer/16 Uživatelský manuál Strana 190